AudioCodes Mediant 3000 User Manual page 907

User's Manual
Parameter
Web: Disconnect Call on Busy
Tone Detection (ISDN)
EMS: Isdn Disconnect On Busy
Tone
[ISDNDisconnectOnBusyTone]
Web: Disconnect Call on Busy
Tone Detection (CAS)
EMS: Disconnect On Detection
End Tones
[DisconnectOnBusyTone]
Version 6.8
The range is 1 to 3600. The default is 0 (20 for E1 and 40 for T1).
Determines whether a call is disconnected upon detection of a
busy tone (for ISDN).

[0] Disable = (Default) Do not disconnect call upon detection of
busy tone.

[1] Enable = Disconnect call upon detection of busy tone.
Notes:

This parameter is applicable only to ISDN protocols.

IP-to-ISDN calls are disconnected on detection of SIT tones
only in call alert state. If the call is in connected state, the SIT
does not disconnect the calls. Detection of busy or reorder
tones disconnects the IP-to-ISDN calls also in call connected
state.

For IP-to-CAS calls, detection of busy, reorder, or SIT tones
disconnect the calls in any call state.
Determines whether a call is disconnected upon detection of a
busy tone.

[0] Disable = Call is not disconnected upon detection of a busy
tone.

[1] Enable = (Default) Call is released upon detection of busy or
reorder (fast busy) tone.
Notes:

This parameter is applicable only to CAS protocols.

This parameter is also applicable to the IP-to-IP application.

This parameter can also be configured in a Tel Profile.
907
51. Configuration Parameters Reference
Description
Mediant 3000