AudioCodes Mediant 3000 User Manual page 287

User's Manual
Parameter
IP Profile ID
[IPGroup_ProfileId]
Local Host Name
[IPGroup_ContactName]
UUI Format
CLI: uui-format
[IPGroup_UUIFormat]
QoE Profile
[IPGroup_QOEProfile]
Bandwidth Profile
[IPGroup_BWProfile]
Media Enhancement Profile
[IPGroup_MediaEnhancement
Profile]
Version 6.8
Assigns an IP Profile to the IP Group. To configure IP Profiles, see
''Configuring IP Profiles'' on page 329.
The default is 0.
Defines the host name (string) that the device uses in the SIP
message's Via and Contact headers. This is typically used to define
an FQDN as the host name. The device uses this string for Via and
Contact headers in outgoing INVITE messages sent to a specific IP
Group, and the Contact header in SIP 18x and 200 OK responses
for incoming INVITE messages received from a specific IP Group.
The Inbound IP Routing table can be used to identify the source IP
Group from where the INVITE message was received.
If this parameter is not configured (default), these headers are
populated with the device's dotted-decimal IP address of the
network interface on which the message is sent.
Note: To ensure proper device handling, this parameter should be
a valid FQDN.
Enables the generation of the Avaya UCID value, adding it to the
outgoing INVITE sent to this IP Group.

[0] Disabled (default)

[1] Enabled
This provides support for interworking with Avaya equipment by
generating Avaya's UCID value in outgoing INVITE messages sent
to Avaya's network. The device adds the UCID in the User-to-User
SIP header.
Avaya's UCID value has the following format (in hexadecimal): 00 +
FA + 08 + node ID (2 bytes) + sequence number (2 bytes) +
timestamp (4 bytes)
This is interworked in to the SIP header as follows:
User-to-User:
00FA080019001038F725B3;encoding=hex
Note: To define the Network Node Identifier of the device for Avaya
UCID, use the 'Network Node ID' (NetworkNodeId) parameter.
Assigns a Quality of Experience Profile rule. For configuring Quality
of Experience Profiles, see ''Configuring Quality of Experience
Profiles'' on page 258.
Assigns a Bandwidth Profile rule. For configuring Bandwidth
Profiles, see ''Configuring Bandwidth Profiles'' on page 262.
Assigns a Media Enhancement Profile rule. For configuring Media
Enhancement Profiles, see ''Configuring Media Enhancement
Profiles'' on page 265.
287
18. Control Network
Description
Mediant 3000