Configuring Ad-Based Routing Rules - AudioCodes Mediant 800B User Manual

The flowchart below summarizes the device's process for querying the AD and routing the
call based on the query results:
Note: If you are using the device's local LDAP cache, see 'Configuring the Device's
LDAP Cache' on page
15.3.11.2

Configuring AD-Based Routing Rules

The following procedure describes how to configure outbound IP routing based on LDAP
queries.

To configure LDAP-based IP routing for Lync Server:
1. Configure the LDAP server parameters, as described in 'Configuring LDAP Servers'
on page 193.
2. Configure the AD attribute names used in the LDAP query:
User's Manual
Figure 15-22: LDAP Query Flowchart
200 for the LDAP query process.
210
Mediant 800B Gateway and E-SBC
Document #: LTRT-10278