Fax Relay For Sg3 Fax Machines - AudioCodes Mediant 3000 User Manual

c. Set the 'V.23 Modem Transport Type' parameter to Disable
(V23ModemTransportType = 0).
d. Set the 'V.32 Modem Transport Type' parameter to Disable
(V32ModemTransportType = 0).
e. Set the 'V.34 Modem Transport Type' parameter to Disable
(V34ModemTransportType = 0).
2. Set the ini file parameter, V34FaxTransportType to 1 (Relay).

To allow V.34 fax relay over T.38:

In the Advanced Parameters page (Configuration tab > VoIP menu > SIP Definitions >
Advanced Parameters), set the 'SIP T.38 Version' parameter to Version 3
(SIPT38Version = 3).

To force V.34 fax machines to use their backward compatibility with T.30 faxes
and operate in the slower T.30 mode:

Set the 'SIP T.38 Version' parameter to Version 0 (SIPT38Version = 0).
Note: Interworking of T.38 Version 3 is supported only for Gateway calls. For SBC
calls, the device forwards T.38 Version 3 transparently (as is) to the other leg (i.e., no
transcoding)..
15.2.3.3 V.34 Fax Relay for SG3 Fax Machines
Super Group 3 (SG3) is a standard for fax machines that support speeds of up to 33.6
kbps through V.34 half duplex (HD) modulation. This procedure below describes how to
configure V.34 (SG3) fax relay support based on ITU Specification T.38 version 3.

To enable support for V.34 fax relay (T.38) at SG3 speed:
1. In the IP Profile table (Configuration tab > VoIP menu > Coders and Profiles > IP
Profile Settings), configure an IP Profile with the 'Fax Signaling Method' parameter
(IpProfile_IsFaxUsed) set to T.38 Relay.
2. In the General Settings page (Configuration tab > VoIP menu > Media > General
Media
(DSPVersionTemplateNumber) to "10" to support up to 1,512 channels. Reset the
device for the settings to take effect.
3. In the Coders Table (Configuration tab > VoIP menu > Coders and Profiles >
Coders), set the coder used by the device to G.729 (or any other supported codec).
Note: See DSP Templates to check the coder support for DSP Template 10.
4. On the Fax/Modem/CID Settings page, do the following settings:
a. 'SIP T.38 Version' to Version 3 (SIPT38Version = 3).
b. 'Fax Relay Max Rate' (RelayMaxRate) to 33,600bps (default).
c. 'CNG Detector Mode' (CNGDetectorMode) to Disable (default).
d. 'V.21 Modem Transport Type' to Disable (V21ModemTransportType = 0).
e. 'V.22 Modem Transport Type' to Disable (V22ModemTransportType = 0).
f. 'V.23 Modem Transport Type' to Disable (V23ModemTransportType = 0).
User's Manual
Settings), set the 'DSP Version Template
190
Mediant 3000
Number' parameter
Document #: LTRT-89738