AudioCodes Mediant 3000 User Manual page 284


To configure an IP Group:
1. Open the IP Group Table page (Configuration tab > VoIP menu > VoIP Network >
IP Group Table).
2. Click Add; the following dialog box appears:
3. Configure an IP Group according to to the parameters described in the table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Parameter
Common Parameters
Index
[IPGroup_Index]
Type
[IPGroup_Type]
User's Manual
Figure 18-5: IP Group Table - Add Dialog Box
Table 18-5: IP Group Table Parameter Descriptions
Defines an index for the new table record.
Defines the type of IP Group:

[0] Server = Used when the destination address, configured by
the Proxy Set, of the IP Group (e.g., ITSP, Proxy, IP-PBX, or
Application server) is known.

[1] User = Represents a group of users such as IP phones and
softphones where their location is dynamically obtained by the
device when REGISTER requests and responses traverse (or
are terminated) by the device. These users are considered
remote (far-end) users.
Typically, this IP Group is configured with a Serving IP Group
that represents an IP-PBX, Application or Proxy server that
serves this User-type IP Group. Each SIP request sent by a
user of this IP Group is proxied to the Serving IP Group. For
registrations, the device updates its internal database with the
Description
284
Mediant 3000
Document #: LTRT-89738