Sdh/Sonet Parameters - AudioCodes Mediant 3000 User Manual

Parameter
[DS3Config_PmOnOff]
[DS3Config_TappingEnable]
Web: Administrative State
[DS3Config_AdminState]
51.10.6.6

SDH/SONET Parameters

The SDH/SONET parameters are described in the table below.
Note: SDH/SONET interface is applicable only to Mediant 3000 with TP-6310.
Parameter
Web/EMS: Transmission Type
[PSTNTransmissionType]
Web: Mode
[SdhFbrGrp_SdhSonetMode]
User's Manual
Enables performance monitoring for the DS3 interface.

[0] = Disables performance monitoring for the specific DS3
interface.

[1] = (Default) Enable.
Enables special DS3 Tapping mode. In this mode, the interface is
capable of receiving a signal with additional 14-dB attenuation to
the standard maximum length.

[0] = Disable (default)

[1] = Enable
Determines the DS3 interface Administrative status. When the
interface Administrative status is set to Down, all 28 underlying
DS1 interfaces are unavailable.

[1] Up = (Default) Administrative status Up.

[2] Down = Administrative status Down (currently, not
supported).
Table 51-57: SDH/SONET Parameters
Defines the PSTN transmission type for the device.

[0] None = (Default) PSTN Transmission type is not defined.

[1] SONET/SDH = Optical SONET or SDH transmission type.

[2] DS3 = Copper T3 transmission type.
Notes:

For this parameter to take effect, a device reset is required.

This parameter is relevant only when the parameter
TDMBusType is set to FRAMERS (2).
Determines the SDH/SONET mode for the PSTN interface,
typically per Fiber Group.

[0] UNKNOWN = Not defined

[1] STM1 = STM-1

[2] OC3 = OC-3
When STM-1 mode is selected, set the
SDHFbrGrp_Mapping_Type parameter to 1 (i.e., Asynchronous
TU12 and E1) and ProtocolType for E1. When OC-3 mode is
selected, set the SDHFbrGrp_Mapping_Type parameter to 0
(Asynchronous VT1.5), 2 (Byte-synchronous VT1.5), or 3
(Asynchronous mapping of DS3 in STS1), and ProtocolType for
DS1.
886
Description
Description
Document #: LTRT-89738
Mediant 3000