Restoring Factory Defaults; Restoring Defaults Using Cli - AudioCodes Mediant 3000 User Manual

User's Manual
40

Restoring Factory Defaults

You can restore the device's configuration to factory defaults using one of the following
methods:

CLI (see ''Restoring Defaults using CLI'' on page 637)

Loading an empty ini file (see ''Restoring Defaults using an ini File'' on page 638)
40.1

Restoring Defaults using CLI

The device can be restored to factory defaults using CLI, as described in the procedure
below.
Note:
Simplex.

To restore factory defaults using CLI:
1. Access the CLI:
a. Connect the RS-232 serial port of the device to the communication port on your
computer. For serial cabling, refer to the Hardware Installation Manual.
b. Establish serial communication with the device using a serial communication
program (such as HyperTerminal
settings:
♦
♦
♦
♦
♦
2. At the CLI prompt, type the following command to access the configuration mode, and
then press Enter:
# conf
3. At the prompt, type the following command to reset the device to default settings, and
then press Enter:
# RestoreFactorySettings
Version 6.8
Restoring factory defaults using CLI is supported only by Mediant 3000
Baud Rate: 115,200 bps
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
TM
) with the following communication port
637
40. Restoring Factory Defaults
Mediant 3000