AudioCodes Mediant 3000 User Manual page 811

User's Manual
Parameter
[IP2IPTranscodingMode]
Web: Enable RFC 4117
Transcoding
[EnableRFC4117Transcodin
g]
Web: Enable Single DSP
Transcoding
[EnableSingleDSPTranscodi
ng]
Network Node ID
net-node-id
[NetworkNodeId]
Web/EMS: Default Release
Cause
[DefaultReleaseCause]
Version 6.8
Note: For this parameter to take effect, a device reset is required.
Note: This parameter is no longer valid and must not be used.
Defines the voice transcoding mode (media negotiation) between two
user agents for the IP-to-IP application. This parameter must always
be set to 1 when using the IP-to-IP application.

[0] Only if Required = Do not force transcoding. Many of the media
settings (such as gain control) are not implemented on the voice
stream. The device passes packets RTP to RTP packets without
any processing.

[1] Force = (Default) Force transcoding on the outgoing IP leg. The
device interworks the media by implementing DSP transcoding.
Enables transcoding of calls according to RFC 4117.

[0] Disable (default)

[1] Enable
Notes:

For this parameter to take effect, a device reset is required.

For more information on transcoding, see Transcoding using Third-
Party Call Control.
Enables the use of a single DSP for transcoding between G.711 and
LBR coders.

[0] Disable (default)

[1] Enable
Notes:

For this parameter to take effect, a device reset is required.

If the TranscodingMode and IP2IPTranscodingMode parameters
are set to 1 (i.e., Force), then this parameter is ignored.
Defines the Network Node Identifier of the device for Avaya UCID.
The valid value range is1 to 0x7FFF. The default is 0.
Notes:

To use this feature, you must set the parameter to any value other
than 0.

To enable the generation by the device of the Avaya UCID value
and adding it to the outgoing INVITE sent to the IP Group (Avaya
entity), use the IP Group table's parameter 'UUI Format'.
Defines the default Release Cause (sent to IP) for IP-to-Tel calls when
the device initiates a call release and an explicit matching cause for
this release is not found.
The default release cause is NO_ROUTE_TO_DESTINATION (3).
Other common values include NO_CIRCUIT_AVAILABLE (34),
DESTINATION_OUT_OF_ORDER (27), etc.
Notes:

The default release cause is described in the Q.931 notation and is
translated to corresponding SIP 40x or 50x values (e.g., 3 to SIP
404, and 34 to SIP 503).

When the Trunk is disconnected or is not synchronized, the internal
cause is 27. This cause is mapped, by default, to SIP 502.

For mapping SIP-to-Q.931 and Q.931-to-SIP release causes, see
Configuring Release Cause Mapping on page 417.

For a list of SIP responses-Q.931 release cause mapping, see
811
51. Configuration Parameters Reference
Description
Mediant 3000