AudioCodes Mediant 3000 User Manual page 712

3. Configure a test call according to the parameters described in the table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Parameter
General Tab
Endpoint URI
[Test_Call_EndpointURI]
Called URI
[Test_Call_CalledURI]
Route By
[Test_Call_RouteBy]
IP Group ID
[Test_Call_IPGroupID]
Destination Address
[Test_Call_DestAddress]
Destination Transport Type
[Test_Call_DestTransportType]
User's Manual
Table 49-1: Test Call Table Parameter Descriptions
Defines the endpoint's URI. This can be defined as a user or
user@host. The device identifies this endpoint only by the URI's
user part. The URI's host part is used in the SIP From header in
REGISTER requests.
The valid value is a string of up to 150 characters. By default, this
parameter is not configured.
Defines the destination (called) URI (user@host).
The valid value is a string of up to 150 characters. By default, this
parameter is not configured.
Defines the type of routing method. This applies to incoming and
outgoing calls.

[0] GW Tel2IP = (Default) Calls are matched by (or routed to)
an SRD and Application type (defined in the SRD and
Application Type parameters below).

[1] IP Group = Calls are matched by (or routed to) an IP Group
ID.

[2] Dest Address = Calls are matched by (or routed to) an SRD
and application type.
Notes:

For REGISTER messages, the option [0] cannot be used as
the routing method.

For REGISTER messages, if option [1] is used, only Server-
type IP Groups can be used.
Defines the IP Group ID to which the test call is sent or from
which it is received.
Notes:

This parameter is applicable only if option [1] is configured for
the 'Route By' parameter.

This IP Group is used for incoming and outgoing calls.
Defines the destination host. This can be defined as an IP
address[:port] or DNS name[:port].
Note: This parameter is applicable only if the 'Route By'
parameter is set to [2] (Dest Address).
Defines the transport type for outgoing calls.

[-1] = Not configured (default)

[0] UDP

[1] TCP

[2] TLS
Note: This parameter is applicable only if the 'Route By'
parameter is set to [2] (Dest Address).
Description
712
Mediant 3000
Document #: LTRT-89738