Pstn Commands; Ldap Commands - AudioCodes Mediant 3000 User Manual

8.4.7

PSTN Commands

The commands under the PSTN directory allow you to perform various PSTN actions.
Command
PstnLoopCommands PS/PH/PLC
PstnSendAlarm
DeleteCasFile
8.4.8

LDAP Commands

The commands under the IPNetworking\OpenLdap directory allow you to perform various
Lightweight Directory Access Protocol (LDAP) actions.
Sub-Command
LdapSTatus
LdapSearch
LDapOpen
User's Manual
Table 8-8: PSTN CLI Command
Short Format Arguments
<TrunkId>
<LoopCode>
<BChannel>
PS/PH/PSA <TrunkId>
<AlarmSendCode>
PS/CAS/DCF <TableIndex>
Table 8-9: LDAP Commands
Arguments
-
<search key> <attribute1>
[<attribute 2> ...<attribute
5>]
-
Activates a loopback on a specific trunk
and B-channel. For loopback on the
entire trunk, set BChannel=(-1).
The valid value options for LoopCode
include the following:

0 = NO_LOOPS

1 = REMOTE_LOOP (whole trunk
only)

2 = LINE_PAYLOAD_LOOP (whole
trunk only not applicable to DS3,
Sonet/SDH)

3 =
LOCAL_ALL_CHANNELS_LOOP
(whole trunk only - not applicable to
DS3 or Sonet/SDH)
Sends an alarm signal at the Tx
interface or on a specific Trunk ID. The
valid value options for AlarmSendCode
include the following:

0 = NO_ALARMS (means stop
sending AIS)

1 = AIS_ALARM

2 = STOP_RAI_ALARM

3 = SEND_RAI_ALARM
Deletes all the device's CAS files when
<TableIndex> is set to -1 (other options
are currently not supported).
Description
Displays the LDAP connection status.
Searches an LDAP server. The parameters
enclosed by [] are optional.
Opens a connection to the LDAP server using
parameters provided in the configuration file.
92
Mediant 3000
Description
Document #: LTRT-89738