AudioCodes Mediant 3000 User Manual page 729

User's Manual
Parameter
EMS: Disable WEB Config
[DisableWebConfig]
[ResetWebPassword]
Version 6.8
Note: For this parameter to take effect, a device reset is required.
Determines whether the entire Web interface is read-only.

[0] = (Default) Enables modifications of parameters.

[1] = Web interface is read-only.
When in read-only mode, parameters can't be modified. In addition, the
following pages can't be accessed: 'Web User Accounts', 'Certificates',
'Regional Settings', 'Maintenance Actions' and all file-loading pages
('Load Auxiliary Files', 'Software Upgrade Wizard', and 'Configuration
File').
Notes:

For this parameter to take effect, a device reset is required.

To return to read/write after you have applied read-only using this
parameter (set to 1), you need to reboot your device with an ini file
that doesn't include this parameter, using the AcBootP utility.
Enables the device to restore the default management users:

Security Administrator user (username "Admin"; password "Admin")

Monitor user (username "User"; password "User")
In addition, all other users that may have been configured (in the Web
Users table) are deleted.

[0] = (Default) Disabled. Currently configured users (usernames and
passwords) are retained.

[1] = Enabled. Default users are restored (see description above)
and all other configured users are deleted.
Notes:

For the parameter to take effect, a device reset is required.

In addition to the ini file (see above), you can also restore the default
user accounts through the following management platforms:

SNMP (restores default users and retains other configured
users:
1) Set acSysGenericINILine to WEBPasswordControlViaSNMP
= 1, and reset the device with a flash burn (set
acSysActionSetResetControl to 1 and acSysActionSetReset to
1).
2) Change the username and password in the
acSysWEBAccessEntry table. Use the following format:
Username acSysWEBAccessUserName: old/pass/new
Password acSysWEBAccessUserCode: username/old/new
729
51. Configuration Parameters Reference
Description
Mediant 3000