AudioCodes Mediant 3000 User Manual page 931

User's Manual
Parameter
as Prefix
[AddTrunkGroupAsPrefix]
Web: Add Trunk ID as Prefix
EMS: Add Port ID As Prefix
[AddPortAsPrefix]
Web/EMS: Add Trunk Group ID
as Prefix to Source
[AddTrunkGroupAsPrefixToS
ource]
Web: Replace Empty
Destination with B-channel
Phone Number
EMS: Replace Empty Dst With
Port Number
[ReplaceEmptyDstWithPortNum
ber]
[CopyDestOnEmptySource]
Web: Add NPI and TON to
Calling Number
EMS: Add NPI And TON As
Prefix To Calling Number
[AddNPIandTON2CallingNumb
er]
Web: Add NPI and TON to
Called Number
EMS: Add NPI And TON As
Prefix To Called Number
[AddNPIandTON2CalledNumbe
r]
Web: Add NPI and TON to
Version 6.8
destination phone number (i.e., called number) for Tel-to-IP calls.

[0] No = (Default) Don't add Trunk Group ID as prefix.

[1] Yes = Add Trunk Group ID as prefix to called number.
Notes:

This option can be used to define various routing rules.

To use this feature, you must configure the Trunk Group IDs
(see Configuring Trunk Group Table on page 391).
Determines whether or not the port numberTrunk ID is added as a
prefix to the called (destination) number for Tel-to-IP calls.

[0] No (Default)

[1] Yes
If enabled, the device adds the following prefix to the called phone
number: port numberTrunk ID (single digit in the range 1 to 83).
This option can be used to define various routing rules.
Determines whether the device adds the Trunk Group ID (from
where the call originated) as the prefix to the calling number (i.e.
source number).

[0] No (default)

[1] Yes
Determines whether the internal channel number is used as the
destination number if the called number is missing.

[0] No (default)

[1] Yes
Note: This parameter is applicable only to Tel-to-IP calls and if the
called number is missing.
Determines whether the destination number is copied to the source
number if no source number is present, for Tel-to-IP calls.

[0] = (Default) Source Number is left empty.

[1] = If the Source Number of a Tel-to-IP call is empty, the
Destination Number is copied to the Source Number.
Determines whether the Numbering Plan Indicator (NPI) and Type
of Numbering (TON) are added to the Calling Number for Tel-to-IP
calls.

[0] No = (Default) Do not change the Calling Number.

[1] Yes = Add NPI and TON to the Calling Number ISDN Tel-to-
IP call.
For example: After receiving a Calling Number of 555, NPI of 1,
and TON of 3, the modified number becomes 13555. This number
can later be used for manipulation and routing.
Determines whether NPI and TON are added to the Called Number
for Tel-to-IP calls.

[0] No = (Default) Do not change the Called Number.

[1] Yes = Add NPI and TON to the Called Number of ISDN Tel-
to-IP call.
For example: After receiving a Called Number of 555, NPI of 1 and
TON of 3, the modified number becomes 13555. This number can
later be used for manipulation and routing.
Determines whether the NPI and TON values are added as the
931
51. Configuration Parameters Reference
Description
Mediant 3000