AudioCodes Mediant 3000 User Manual page 810

Parameter
[XChannelHeader]
Web/EMS: Progress
Indicator to IP
[ProgressIndicator2IP]
[EnableRekeyAfter181]
[NumberOfActiveDialogs]
EMS: Transparent Coder On
Data Call
[TransparentCoderOnDataC
all]
Web: IP to IP Application
[EnableIP2IPApplication]
User's Manual

[0] Disable = (Default) X-Channel header is not used.

[1] Enable = X-Channel header is generated by the device and sent
in INVITE messages and 180, 183, and 200 OK SIP responses.
The header includes the Trunk number, B-channel, and the
device's IP address.
For example, 'x-channel: DS/DS1-5/8;IP=192.168.13.1', where:

'DS/DS-1' is a constant string

'5' is the Trunk number

'8' is the B-channel

'IP=192.168.13.1' is the device's IP address
Global parameter that defines the progress indicator (PI) sent to the IP.
You can also configure this functionality per specific calls, using IP
Profiles (IpProfile_ProgressIndicator2IP) or Tel Profiles. For a detailed
description of this parameter and for configuring this functionality in the
IP Profile table, see Configuring IP Profiles on page
Profile table, see Configuring Tel Profiles on page 326.
Note: If this functionality is configured for a specific profile, the settings
of this global parameter is ignored for calls associated with the profile.
Enables the device to send a re-INVITE with a new (different) SRTP
key (in the SDP) if a SIP 181 response is received ("call is being
forwarded"). The re-INVITE is sent immediately upon receipt of the 200
OK (when the call is answered).

[0] = Disable (default)

[1] = Enable
Note: This parameter is applicable only if SRTP is used.
Defines the maximum number of concurrent, outgoing SIP REGISTER
dialogs. This parameter is used to control the registration rate.
The valid range is 1 to 20. The default is 20.
Notes:

Once a 200 OK is received in response to a REGISTER message,
the REGISTER message is not considered in this maximum count
limit.

This parameter applies only to outgoing REGISTER messages (i.e.,
incoming is unlimited).

[0] = (Default) Only use coders from the coder list.

[1] = Use Transparent coder for data calls (according to RFC
4040).
The Transparent coder can be used on data calls. When the device
receives a Setup message from the ISDN with 'TransferCapabilities =
data', it can initiate a call using the coder 'Transparent' (even if the
coder is not included in the coder list).
The initiated INVITE includes the following SDP attribute:
a=rtpmap:97 CLEARMODE/8000
The default payload type is set according to the CodersGroup
parameter. If the Transparent coder is not defined, the default is set to
56. The payload type is negotiated with the remote side, i.e., the
selected payload type is according to the remote side selection. The
receiving device must include the 'Transparent' coder in its coder list.
Enables the IP-to-IP Call Routing application.

[0] Disable (default)

[1] Enable
810
Description
329
Document #: LTRT-89738
Mediant 3000
or in the Tel