Dhcp Parameters - AudioCodes Mediant 3000 User Manual

Parameter
EMS: DNS Information
[SRV2IP]

51.2.8 DHCP Parameters

The Dynamic Host Control Protocol (DHCP) parameters are described in the table below.
Parameter
Web: Enable DHCP
EMS: DHCP Enable
[DHCPEnable]
EMS: DHCP Speed Factor
[DHCPSpeedFactor]
User's Manual
names into DNS A-Records. Three different A-Records can be assigned
to a host name. Each A-Record contains the host name, priority, weight,
and port. The format of this parameter is as follows:
[SRV2IP]
FORMAT SRV2IP_Index = SRV2IP_InternalDomain,
SRV2IP_TransportType, SRV2IP_Dns1, SRV2IP_Priority1,
SRV2IP_Weight1, SRV2IP_Port1, SRV2IP_Dns2, SRV2IP_Priority2,
SRV2IP_Weight2, SRV2IP_Port2, SRV2IP_Dns3, SRV2IP_Priority3,
SRV2IP_Weight3, SRV2IP_Port3;
[\SRV2IP]
For example:
SRV2IP 0 =
SrvDomain,0,Dnsname1,1,1,500,Dnsname2,2,2,501,$$,0,0,0;
For a detailed description of this table, see ''Configuring the Internal SRV
Table'' on page 145.
Table 51-16: DHCP Parameters
Enables Dynamic Host Control Protocol (DHCP) functionality.

[0] Disable (default)

[1] Enable
Notes:

For this parameter to take effect, a device reset is required.

For a detailed description of DHCP, see ''DHCP-based Configuration
Server'' on page 621.

This parameter is a "hidden" parameter. Once defined and saved to
flash memory, its value doesn't revert to default even if the parameter
doesn't appear in the ini file.
Defines the DHCP renewal speed.

[0] = Disable

[1] = (Default) Normal

[2] to [10] = Fast
When set to 0, the DHCP lease renewal is disabled. Otherwise, the
renewal time is divided by this factor. Some DHCP-enabled routers
perform better when set to 4.
Note: For this parameter to take effect, a device reset is required.
750
Description
Description
Document #: LTRT-89738
Mediant 3000