AudioCodes Mediant 3000 User Manual page 836

Parameter
Web: Gateway RTCP XR Report
Mode
EMS: Report Mode
[RTCPXRReportMode]
Web: SBC RTCP XR Report Mode
[SBCRtcpXrReportMode]
publication-ip-group-id
[PublicationIPGroupID]
User's Manual
numerical IP address or as a domain name.
Note:

Instead of sending RTCP XR to an ESC server, you can
send RTCP XR to an IP Group (see the
PublicationIPGroupID parameter).

This parameter is applicable only to the Gateway
application.
Enables the device to send RTCP XR in SIP PUBLISH
messages to the Event State Compositor (ESC) server and
defines the interval at which they are sent.

[0] Disable = (Default) RTCP XR is not sent.

[1] End Call = RTCP XR is sent at the end of the call.

[2] End Call & Periodic = RTCP XR is sent at the end of the
call and periodically according to the RTCPInterval
parameter.
[3] End Call & End Segment = RTCP XR is sent at the end of
the call and at the end of each media segment of the call. A
media segment is a change in media, for example, when the
coder is changed or when the caller toggles between two
called parties (using call hold/retrieve). The RTCP XR sent at
the end of a media segment contains information only of that
segment. If the segment does not contain RTP/RTCP content,
the RTCP XR is not sent. For call hold, the device sends an
RTCP XR each time the call is placed on hold and each time it
is retrieved. In addition, the Start timestamp in the RTCP XR
indicates the start of the media segment; the End timestamp
indicates the time of the last sent periodic RTCP XR (typically,
up to 5 seconds before reported segment ends).Note: This
parameter is applicable only to the Gateway application.
Enables the sending of RTCP XR reports of QoE metrics at
the end of each call session (i.e., after a SIP BYE). The RTCP
XR is sent in the SIP PUBLISH message.

[0] Disable (default)

[1] End of Call
Note: This parameter is applicable only to the SBC
application.
Defines the IP Group to where the RTCP XR is sent. If the
value is -1 (default) or 0, the RTCP XR is sent to the ESC
server, as configured by the RTCPXREscIP parameter.
Note: The parameter is applicable only to the Gateway
application.
836
Description
Document #: LTRT-89738
Mediant 3000