AudioCodes Mediant 3000 User Manual page 897

User's Manual
Parameter
EMS: Remove Calling Name
For Trunk Mode
[RemoveCallingNameForTru
nk_x]
Web/EMS: Progress Indicator
to ISDN
[ProgressIndicator2ISDN_x]
Web: Set PI in Rx Disconnect
Message
EMS: Set PI For Disconnect
Msg
[PIForDisconnectMsg_x]
EMS: Connect On Progress Ind
[ConnectOnProgressInd]
Web: Local ISDN Ringback
Tone Source
EMS: Local ISDN RB Source
[LocalISDNRBSource_x]
Version 6.8
calls, per trunk.

[-1] Use Global Parameter = (Default) Settings of the global
parameter RemoveCallingName are used.

[0] Disable = Does not remove Calling Name.

[1] Enable = Remove Calling Name.
Note: The x in the ini file parameter name denotes the trunk
number, where 0 is Trunk 1.
Determines the Progress Indicator (PI) to ISDN per trunk.

[-1] Not Configured = (Default) The PI in ISDN messages is set
according to the parameter PlayRBTone2Tel.

[0] No PI = PI is not sent to ISDN.

[1] PI = 1; [8] PI = 8: The PI value is sent to PSTN in
Q.931/Proceeding and Alerting messages. Typically, the
PSTN/PBX cuts through the audio channel without playing local
ringback tone, enabling the originating party to hear remote Call
Progress Tones or network announcements.
Note: The x in the ini file parameter name denotes the trunk
number, where 0 is Trunk 1.
Defines the device's behavior per trunk when a Disconnect
message is received from the ISDN before a Connect message is
received.

[-1] Not Configured = (Default) Sends a 183 SIP response
according to the received progress indicator (PI) in the ISDN
Disconnect message. If PI = 1 or 8, the device sends a 183
response, enabling the PSTN to play a voice announcement to
the IP side. If there isn't a PI in the Disconnect message, the call
is released.

[0] No PI = Doesn't send a 183 response to IP. The call is
released.

[1] PI = 1; [8] PI = 8: Sends a 183 response to IP.
Note: The x in the ini file parameter name denotes the trunk
number, where 0 is Trunk 1.
Enables the play of announcements from IP to PSTN without the
need to answer the Tel-to-IP call. It can be used with PSTN
networks that don't support the opening of a TDM channel before
an ISDN Connect message is received.

[0] = (Default) Connect message isn't sent after SIP 183 Session
Progress message is received.

[1] = Connect message is sent after SIP 183 Session Progress
message is received.
Determines whether the ringback tone is played to the ISDN by the
PBX/PSTN or by the device, per trunk.

[0] PBX = (Default) PBX/PSTN plays the ringback tone.

[1] Gateway = The device plays the ringback tone.
Notes:

This parameter is applicable to ISDN protocols.

This parameter is used together with the PlayRBTone2Trunk
parameter.

The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
897
51. Configuration Parameters Reference
Description
Mediant 3000