AudioCodes Mediant 3000 User Manual page 869

User's Manual
Parameter
[AdminState]
[TrunkAdministrativeState_x]
Web/EMS: Line Build Out
Overwrite
[LineBuildOut.OVERWRITE]
Web/EMS: Line Build Out Loss
[LineBuildOut.Loss]
Web/EMS: Line Build Out
XPM0
[LineBuildOut.XPM0]
Web/EMS: Line Build Out
XPM1
[LineBuildOut.XPM1]
Web/EMS: Line Build Out
XPM2
[LineBuildOut.XPM2]
[TDMHairPinning]
Version 6.8
Defines the administrative state for all trunks.

[0] = Lock the trunk; stops trunk traffic to configure the trunk
protocol type.

[1] = Shutting down (read only).

[2] = (Default) Unlock the trunk; enables trunk traffic.
Notes:

For this parameter to take effect, a device reset is required.

When the device is locked from the Web interface, this
parameter changes to 0.

To define the administrative state per trunk, use the
TrunkAdministrativeState parameter.
Defines the administrative state per trunk, where x denotes the
trunk number.

[0] = Lock the trunk; stops trunk traffic to configure the trunk
protocol type.

[1] = shutting down (read only).

[2] = (Default) Unlock the trunk; enables trunk traffic.
Overwrites the Framer's XPM register values. These registers
control the line pulse shape.

[0] OFF = (Default) No overwrite.

[1] ON = Overwrite.
Defines the line build out loss for the selected T1 trunk.

[0] 0 dB (default)

[1] -7.5 dB

[2] -15 dB

[3] -22.5 dB
Note: This parameter is applicable only to T1 trunks.
Defines the Framer's XPM0 register value (line pulse shape
control).
The range is 0 to 255. The default is 0.
Note: This parameter is applicable only when the parameter
TrunkConfig.LineBuildOut.Overwrite is set to 1.
Defines the Framer's XPM1 register value (line pulse shape
control).
The range is 0 to 255. The default is 0.
Note: Applicable only when TrunkConfig.LineBuildOut.Overwrite is
set to 1.
Defines the Framer's XPM2 register value (line pulse shape
control).
The range is 0 to 255. The default is 0.
Note: This parameter is applicable only when the parameter
TrunkConfig.LineBuildOut.Overwrite is set to 1.
Defines static TDM hair-pinning (cross-connection) performed at
initialization. The connection is between trunks with an option to
exclude a single B-channel in each trunk.
Format example: T0-T1/B3,T2-T3,T4-T5/B2.
Note: For this parameter to take effect, a device reset is required.
869
51. Configuration Parameters Reference
Description
Mediant 3000