Configuring Sip User Part For Srs; Interworking Sip-Based Media Recording With Third-Party Vendors; Genesys - AudioCodes Mediant 800B User Manual

User's Manual

15.2.3 Configuring SIP User Part for SRS

You can configure the SIP user part of the Request-URI for the recording server (SRS).
The device inserts this user part in the SIP To header of the INVITE message sent to the
SRS.

To configure the SIP user part for SRS:
1. Open the SIP Recording page (Configuration tab > VoIP menu > Services > SIP
Recording).
2. In the 'Recording Server (SRS) Destination Username' field, enter a user part value
(string of up to 50 characters).
3. Click Submit, and then save ("burn") your settings to flash memory.
15.2.4 Interworking SIP-based Media Recording with Third-Party
Vendors
The device can interwork the SIP-based Media Recording feature with third-party vendors,
as described in the following subsections.

15.2.4.1 Genesys

The device's SIP-based media recording can interwork with Genesys' equipment. Genesys
sends its proprietary X-Genesys-CallUUID header (which identifies the session) in the first
SIP message, typically in the INVITE and the first 18x response. If the device receives a
SIP message with Genesys SIP header, it adds the header's information to AudioCodes'
proprietary tag in the XML metadata of the SIP INVITE that it sends to the recording server,
as shown below:
<ac:GenesysUUID
xmlns="urn:ietf:params:xml:ns:Genesys">4BOKLLA3VH66JF112M1CC9VHKS1
4F0KP</ac:GenesysUUID>
No configuration is required for this support.
Version 6.8 209 Mediant 800B Gateway and E-SBC
15. Services