Stratasys F170 User Manual page 188

Installing the Material Bay
1. Gently install the material bay to the open drawer. See
2. Using a 2.5mm hex wrench, fasten the mounting screws securing the material bay to the top of
the drawer. See
3. Close the material bay drawer.
4. From the back of the printer, connect the cable to the material drive controller board connector.
See Figure 7-18.
5. Press and hold the locking tab to install the filament tube to the rear of the material bay. See
Figure 7-18.
Note: Make sure that there is 0.83 inch of tube from the tube support finger to the
bottom of the switch block assembly. See
Figure 7-21:
6. Open the material bay drawer and view the filament tube from the rear of the printer. Make sure
that the filament tube is routed properly with no interference.
7. Install the rear tool tray.
8. Install the material spool to the material bay.
9. Close and latch the material bay.
10. Close the material bay drawer.
11. Install the rear panel. See
12. Power ON the printer. See
13. Load material. See
Figure 7-20.
Correct material bay material tube installation
"Installing the Rear Panel" on page
"Powering ON the Printer" on page
"Loading Material" on page
Figure 7-20.
Figure 7-21.
170.
105.
108.
179