Stratasys F170 User Manual page 217

Model head not initialized
• Indicates that head data is not ready. This is only displayed when the printer is initializing a newly
installed head, or if the initialization process failed.
• Correct condition - wait at least 60 seconds after the error is first displayed. If the error persists, open
the top cover and unclip the head cable from the model head. Wait a few seconds and then
reconnect the head cable to the model head and close the top cover (see
page 117 for details). If the error persists there is likely a problem with either the head or the head
cable; please contact Stratasys Customer Support or your regional Stratasys office for further
assistance (see "Getting Help" on page 204
Support head not initialized
Indicates that head data is not ready. This is only displayed when the printer is initializing a newly
•
installed head, or if the initialization process failed.
• Correct condition - wait at least 60 seconds after the error is first displayed. If the error persists, open
the top cover and unclip the head cable from the support head. Wait a few seconds and then
reconnect the head cable to the support head and close the top cover (see
page 117 for details). If the error persists there is likely a problem with either the head or the head
cable; please contact Stratasys Customer Support or your regional Stratasys office for further
assistance (see "Getting Help" on page 204
Load model material
• Indicates that model material has not been loaded into the printer.
• Correct condition - load model material. See
Load support material
• Indicates that support material has not been loaded into the printer.
• Correct condition - load support material. See
Replace invalid model spool
Indicates that the material spool is invalid. Invalid materials are materials not licensed or not
•
compatible with the associated head type.
• Correct condition - remove the invalid material spool and replace it with a valid spool. See
"Removing Material Spools" on page 114
instructions.
Replace invalid support spool
• Indicates that the material spool is invalid. Invalid materials are materials not licensed or not
compatible with the associated head type.
• Correct condition - remove the invalid material spool and replace it with a valid spool. See
"Removing Material Spools" on page 114
instructions.
Replace empty model spool
• Indicates that the material spool has run out of material.
• Correct condition - remove the empty material spool and replace with a new spool. See
an empty Material Spool" on page 114
Replace empty support spool
• Indicates that the material spool has run out of material.
• Correct condition - remove the empty material spool and replace with a new spool. See
an empty Material Spool" on page 114
for contact information).
for contact information).
"Loading Material" on page 108
"Loading Material" on page 108
and "Material Spool Installation" on page 109
and "Material Spool Installation" on page 109
and "Material Spool Installation" on page 109
and "Material Spool Installation" on page 109
208
"Head Replacement" on
"Head Replacement" on
for instructions.
for instructions.
for
for
"Removing
for instructions.
"Removing
for instructions.