Stratasys F170 User Manual page 170
F123 series shared office 3d printers
Hide thumbs
Also See for F170:
- Operation and maintenance manual (91 pages) ,
- Site preparation manual (22 pages)
Table of Contents
Advertisement
10.
The touchscreen will refresh to indicate that the printer is verifying the upgrade file.
Note: The verification process will take several minutes; please be patient.
Figure 7-5:
Verifying Software Upgrade
11.
Once the verification process is complete, the printer will automatically reboot and begin
installing the upgrade file. A variety of output will be displayed on the touchscreen during the
installation process.
Note: The installation process will take several minutes; please be patient.
12.
Once the Controller Software upgrade is installed the printer will conduct its regular startup
process and automatically perform an XY Gantry Calibration (see
page 105
for details).
"Powering ON the Printer" on
161
Advertisement
Table of Contents
