Stratasys F170 User Manual page 208

Installing the Oven Door Latch
1. Using a 2.5 mm hex wrench, install the sensor bracket mounting screws (2) to secure the sensor
mounting bracket to the oven door latch assembly. See
2. Using a 4 mm socket wrench, install the door latch assembly mounting nuts (2) to secure the
door latch assembly inside the oven door assembly. See
3. Connect the door latch assembly sensor cable connectors (2).
4. Install the inside door panel into the door assembly. See
A. Angle the inside door panel slightly and insert the pivot nuts into the lower notches on both
sides of the door frame.
B. Gently press down on the door panel until the pivot nuts are fully seated inside the door
frame.
C. Rotate the top of door panel toward the door assembly. Gently press in the pivot arms to
insert them into the upper notches on both sides of the door frame.
D. Close the door panel and make sure that the panel and frame mounting holes are aligned.
Figure 7-41:
5. Using a 2.5 mm hex wrench, install the inside door panel mounting screws (11). See
6. Close the oven door.
Inside oven door panel detail
Pivot Arm
Notch
Pivot Nut
Notch
Figure 7-40.
Figure 7-39.
Figure 7-41.
199
Figure 7-38.