Tip Calibration - Stratasys F170 User Manual

TIP CALIBRATION

The printer's calibration status will be displayed within the Tip Calibration row. Calibrated or Not Calibrated will
be displayed depending on the printer's Calibration status.
Pressing anywhere within the Tip Calibration row will open a page allowing you to select from a variety of tip
calibration options. You cannot build parts on the printer until the printer's tips are calibrated.
Figure 6-2: Tip Calibration
The Tip Calibration page contains an option for performing an Automatic Tip Calibration as well as a Manual Tip
Calibration. Pressing the Start button associated with either of these options will allow you to perform that
particular calibration procedure. Each calibration procedure is delivered in the form of a wizard which will guide
you through the process of performing the calibration procedure.
Figure 6-3: Tip Calibration Options
141