SETTINGS
The Settings page allows you to turn a variety of printer settings on/off (including part placement, standby mode,
etc.), configure the language and units the printer/UI is configured for, and adjust the brightness of the
touchscreen display.
To access the Settings page, press the Settings button within the Tools page; a screen similar to the following
will be displayed. Use the scrollbar (along the right side of the page) to scroll up or down through the list of
available options.
Figure 4-36:
WAIT FOR PART
After sending a job file to the printer you would typically need to navigate within the User Interface in order to
select the job from the Queue and start the build. The wait for part setting will instead allow you to send a job file
to the printer which will then immediately start building once received by the printer.
Figure 4-37:
Settings Page
Wait for Part
79