Build Abort Errors - Stratasys F170 User Manual

BUILD ABORT ERRORS

Note: All abort related errors must be acknowledged on the User Interface
before the printer is put into an aborted state.
Aborted by user
• Indicates that the abort was initiated by the operator.
Correct condition - remove the aborted build from the printer, see
•
on page 129
Failed to find Z zero
Indicates that the Z stage failed to find its home position.
•
Correct condition - verify that there is nothing obstructing the calibration targets on the platen, see
•
"Cleaning the Platen" on page 164
Failed to process the part
An error occurred when attempting to translate the CMB file into commands for the printer.
•
Correct condition - often the result of a corrupted or outdated CMB file. Ensure that your printer's
•
software version is up to date (see
using the correct version of GrabCAD Print software. Reprocess, reorient, and resend the job file to
the printer using GrabCAD Print (see
build (see
Failed to load toolpaths
Printer unexpectedly lost job information during the build.
•
Correct condition - reprocess, reorient, and resend the job file to the printer using GrabCAD Print
•
(see "GrabCAD Print Software" on page
the reprocessed file, attempt to build a different file to see if the error occurs again. If so, contact
Stratasys Customer Support or your regional Stratasys office (see
contact information).
Failed to calibrate tip offsets
Indicates that the printer failed to calibrate tip offsets.
•
Correct condition - perform an automatic tip calibration
•
calibration fails, perform a manual tip calibration
fails again, contact Stratasys Customer Support or your regional Stratasys office (see
on page 204
Active spool removed
• Indicates that the active material spool was removed. This is only displayed when the printer is
preparing for a build.
Correct condition - install a material spool and load model material. See
•
on page 109
Model head removed
Indicates that the printer lost contact with the model material spool's memory chip or the material
•
drive controller inadvertently lifted.
• Correct condition - ensure that the material spool is seated correctly within the material drive. If so,
remove the spool and then reinstall it (see
Spool Installation" on page
spool.
for instructions.
"Basic Job Build Tasks" on page 120
for contact information).
and "Loading Material" on page 108
109). If this does not correct the error, remove the spool and install a new
for instructions.
"Updating Controller Software" on page
"GrabCAD Print Software" on page
for instructions).
37). If you encounter the same error when rebuilding with
("Automatic Tip Calibration" on page
("Manual Tip Calibration" on page
for instructions.
"Removing Material Spools" on page 114
214
"Removing a Part from the Printer"
158) and that you are
37) and then restart the
"Getting Help" on page 204
144). If calibration
"Getting Help"
"Material Spool Installation"
and
for
142). If
"Material