End of model filament detected
•
Indicates that filament from the material spool has not been detected by the filament present switch
in the material drive.
•
Correct condition - slowly turn the material spool and feed filament into the drive mechanism.
Filament needs to be advanced approximately 2 inches (50.8 mm) to reach the filament present
switch. See
"Loading Material" on page 108
End of support filament detected
Indicates that filament from the material spool has not been detected by the filament present switch
•
in the material drive.
•
Correct condition - slowly turn the material spool and feed filament into the drive mechanism.
Filament needs to be advanced approximately 2 inches (50.8 mm) to reach the filament present
switch. See
"Loading Material" on page 108
Cooler module not installed
•
Indicates that the bead cooler has not been installed with the associated PLA material head.
•
Correct condition - install the bead cooler.
for instructions.
for instructions.
209