Loading A File - Stratasys F170 User Manual

Figure 4-4: Notification Details

LOADING A FILE

Note: A job file must be loaded onto the printer and selected for building before
the job's details will be displayed within the Build page.
The Print Job Information Panel is empty upon initial startup and the Build Status Display reflects its idle state.
When there are no job files are available within the Job Queue, the Load File button will be displayed within the
Build page. Visibility of this button is dependent upon the method used to load job files to the printer.
A job must be selected for building before the job's details will be displayed within the Build page. In order to
build a job, you must first load the job's corresponding job file to the printer. Job files can be loaded via network
transfer (Ethernet or Wi-Fi) using the GrabCAD Print application on your workstation PC or by plugging a USB
flash drive into one of the printer's USB ports and navigating to the job file via the Queue page (see
Job to the Job Queue" on page 51
Job Queue. Job files can be sorted as needed within the Queue page allowing you to select the job you'd like to
build (see "Editing the Job Queue" on page 55
• If you send a single job file to the printer via network transfer using GrabCAD Print, the job's details
will automatically be displayed within the Build Status Display once the job file is received by the
printer, as this job will be the only item in the Job Queue. The Load File button will be hidden from
view once the job file is received by the printer via network transfer.
for details). The job file you wish to build must be the first item listed in the
for details).
41
"Adding a