Stratasys F170 User Manual page 192

9. Remove the head ribbon cables and cable brackets from the printer. See
Figure 7-25:
Installing the Head Ribbon Cables
1. Install the rear ribbon cable bracket to cutouts at the back, top of the printer frame.
See Figure 7-24.
2. Using a 3 mm hex wrench install the mounting screws (3) to fasten the front ribbon cable bracket
to the back of the toggle assembly. See
3. Connect the rear head ribbon cable connectors (2) to the I/O board (J6 and J7). See
4. Connect the front head ribbon cable connectors (2) to the material and support heads. See
Figure 7-22.
5. Install the rear panel. See
6. Close the top cover.
Head Ribbon Cables and Brackets
"Installing the Rear Panel" on page
Figure 7-23.
183
Figure 7-25.
170.
Figure 7-22.