Stratasys F170 User Manual page 162

F. If a Z offset adjustment is required you will need to rebuild the calibration part. To do so:
• After entering your Z offset adjustment press the Apply button within the Manual Tip Calibration
page (see
continue to change the adjustment values, you must press the Apply button again to save the
changes.
Note: The Cancel button can be used to reset an adjustment value entered prior to pressing
the Apply button. Once the Apply button is pressed, values will be saved and the printer's
calibration settings will reflect the adjustment value entered. Use caution when entering an
adjustment value to ensure it is correct prior to pressing the Apply button.
After pressing the Apply button, the Close button will appear. Press the Close button to return to
•
the initial Tip Calibration page.
Figure 6-18: Close Button Location
• Repeat step 1
• Repeat the instructions in
matches the model tip slice height ±0.0005 in. (0.01 mm).
4. Once you're finished adjusting for XY and Z, press the Apply button within the Manual Tip
Calibration page and your calibration adjustment(s) will be saved. Press the Close button to exit
the page.
Figure 6-9 for button location). Your calibration adjustment(s) will be saved. If you
to build a calibration part.
step 3. Continue to check and adjust for Z offset until the support layer
153