Printer Setup; General Information; Welcome Kit Contents - Stratasys F170 User Manual
F123 series shared office 3d printers
Hide thumbs
Also See for F170:
- Operation and maintenance manual (91 pages) ,
- Site preparation manual (22 pages)
Table of Contents
Advertisement
2 PRINTER SETUP
This chapter describes basic setup of the F123 Series.
GENERAL INFORMATION
WELCOME KIT CONTENTS
The printer's Welcome Kit contains the Welcome Insert document and common tools you will need to maintain
the printer. Use the following figures and tables to identify the contents of the Welcome Kit.
Figure 2-1:
Welcome Kit Contents - Documents and Cables
1
4
Table 2-1:
Key for Figure 2-1
Welcome Insert
1
Document
RJ45 Cable
2
3
USB Flash Drive
4
AC Cable (US or
Euro)
2
US Cable
Contains instructions for downloading the F123 Series User Guide (this document).
This cable is used to establish a network connection between the F123 Series printer and
your Ethernet network. See
"Making the Network Connection" on page 13.
The printer features 3 USB ports (see
alternate method to sending job files to the printer via GrabCAD Print, this flash drive can
be used to store processed job files which you build frequently (see
Job Queue" on page
51).
This cable provides the power connection to the printer. See
Cable" on page 13.
When connecting the cable, select the cable appropriate for your
location (US cable or Euro cable).
OR
Euro Cable
Figure 3-3 on page 22
for port locations). As an
"Connecting the Power
7
3
"Adding a Job to the
Advertisement
Table of Contents
