CLEANING THE OVEN DOOR GLASS SURFACES
Required Tools
•
2.5 mm hex wrench
Accessing the Oven Door Glass
1.
Power off the printer. See
2.
Allow the oven to cool.
3.
Open the oven door.
4.
Using a 2.5 mm hex wrench, remove the inside door panel mounting screws (11). See
38.
Figure 7-9:
Inside door panel mounting screw locations
5.
Pivot the inside door panel away from the door assembly. The pivot arms will prevent the door
panel from fully separating. See
6.
Clean the glass surfaces with a commercial glass cleaner.
Installing the Door Panel
1.
Push the top of the door panel toward the door assembly.
2.
Close the door panel and make sure that the panel and frame mounting holes are aligned.
3.
Using a 2.5 mm hex wrench, install the inside door panel mounting screws (11). See
Note: Do not over-tighten the inside door panel mounting screws.
4.
Close the oven door.
"Powering Off" on page
Inside
Pivot arm (2)
door panel
Figure
7-9.
169.
168
Figure 7-
Figure
7-9.