HEAD RIBBON CABLES
Required Tools
3 mm hex wrench
•
Removing the Head Ribbon Cables
Note: Make sure to disconnect the head ribbon cables while the printer is
powered ON to ensure that auto-calibration occurs after re-installation.
1.
With the printer powered ON, open the top cover.
2.
Move the X bridge to the front of the gantry enclosure.
3.
Disconnect the head ribbon cable connectors (2) from the tops of the material and support
heads. See
Figure
4.
Power OFF the printer.
5.
Remove the rear panel. See
6.
Disconnect the head ribbon cable connectors (2) from the I/O board (J6 and J7).
See
Figure
7-22.
Figure 7-22:
7-22.
"Removing the Rear Panel" on page
Head Ribbon Cable Connections
170.
Model Head J6
181
Support Head J7