Stratasys F170 User Manual page 191
F123 series shared office 3d printers
Hide thumbs
Also See for F170:
- Operation and maintenance manual (91 pages) ,
- Site preparation manual (22 pages)
Table of Contents
Advertisement
7.
Using a 3 mm hex wrench, remove the front ribbon cable bracket mounting screws (3) on the
back of the toggle assembly. Retain the screws for re-installation. See
Figure 7-23:
Front Ribbon Cable Bracket Mounting Screw Locations
8.
Lift and disengage the rear ribbon cable bracket from the back, top of the printer frame.
See
Figure
7-24.
Figure 7-24:
Rear Ribbon Cable Bracket Mounting Detail
182
Figure
7-23.
Advertisement
Table of Contents
