Stratasys F170 User Manual page 92
F123 series shared office 3d printers
Hide thumbs
Also See for F170:
- Operation and maintenance manual (91 pages) ,
- Site preparation manual (22 pages)
Table of Contents
Advertisement
To configure this setting, press anywhere within the row; the First Layer Material page will be displayed. Use the
radio buttons within this page to select between Model and the Default material, which could be either model or
support material.
Figure 4-44:
UNITS
The Units row displays the type of units the printer is configured for, English (inches) or Metric.
Figure 4-45:
To configure this setting, press anywhere within the row; the Units page will be displayed. Use the radio buttons
within this page to select between English and Metric units; English is selected by default.
Figure 4-46:
Configure First Layer Material
Units
Configure Units
83
Advertisement
Table of Contents
