Stratasys F170 User Manual page 130

3. Place a new substrate onto the platen and lock the substrate into its build position by lifting up on
the substrate ejection handle.
Caution: Always wear gloves when installing the substrate. Hand oils on the
substrate surface will result in poor part adhesion.
Note: Never print in the same location more than once on a substrate when
building a job.
Using substrates not provided by Stratasys may impact part quality and printer
reliability.
4. Make sure that the tip wipe assembly's brushes as well as the printer's tips are clean and that the
purge area is free of purged material debris.
121