4.
Rear side panels only: The rear side panels are held in place by a standoff that is retained
inside the printer frame. Slide the panel away from the printer to disengage the retaining standoff.
See
Figure
7-13.
Figure 7-13:
5.
Remove the side panel from the printer.
Installing the Side Panels
1.
Insert the side panel retaining standoff into the hole in the printer frame and slide the panel into
place until it aligns with the mounting screw holes. See
2.
Use a 5 mm hex wrench to reinstall the mounting screws (6). See
Rear Side Panel Retaining Standoff Detail
Figure
7-13.
Figure
172
Retaining Standoff
7-12.