MATERIAL BAYS
Required Tools
2.5 mm hex wrench
•
3 mm hex wrench
•
Removing the Material Bay
1.
Unload material. See
2.
Open the material bay drawer.
3.
Unlatch and open the material bay lid.
4.
Remove the existing material spool from the material bay.
5.
Place the used material spool into an airtight bag and seal it.
6.
Close the material bay lid.
7.
Close the material bay drawer.
8.
Power OFF the printer. See
9.
Remove the rear panel. See
10.
From the rear of the corresponding material bay, press and hold the locking tab to release the
material tube.
11.
Disconnect the material tube from the material bay and release the locking tab. See
Figure 7-18:
12.
Disconnect the cable from the material drive controller board connector. See
"Unloading Material" on page
"Powering Off" on page
"Removing the Rear Panel" on page
Disconnecting material tube
113.
169.
Locking Tab
Material drive
controller board
connector
177
170.
Figure
Figure
7-18.
7-18.