Stratasys F170 User Manual page 89

Pressing anywhere within the row will open the Wait For Part page. Opening this page will automatically put the
printer into a state where it will wait to receive a job file to build immediately. After putting the printer into this
state, you must send the processed job file to the printer via GrabCAD Print. Once the job file is received by the
printer, the job will automatically start building. As such, ensure that the printer has been properly prepared for
the start of a build (see
Figure 4-38:
KEEP PREVIOUS JOB
For privacy reasons, you have the option of choosing whether or not the printer's previous job is stored within
the Job Queue. If you're concerned about other users of your printer seeing what you've built, this setting allows
you to prevent other users from accessing the printer's previous job. When this setting is set to On, the printer
will store its previous job file making it available for re-selection within the Job Queue. When this setting is set to
Off, the printer's previous job file will be deleted from the Job Queue upon completion of the build. The job's file
will need to be resent to the printer in order to be built again.
Figure 4-39:
"Before a Build" on page 120
Waiting for Part
Keep Previous Job
and "Preparing the Printer" on page 120
80
for details).