Stratasys F170 User Manual page 194

Installing the Touchscreen Display
1. Reconnect the touch extender cable and the display cable to the back of the touchscreen display.
Note: Orient the shiny side of the connector away from the display.
The flat display cable connector is fragile. Simultaneously push both corners of
the connector straight in, without rocking back and forth.
2. Align the touchscreen's standoff fasteners (4) with the corresponding slots in the mounting plate
and gently press it down until it is fully seated. See
Note: If all four of the standoff fasteners are not properly installed, the mounting
screw holes on top of the brackets will not align.
Figure 7-27:
Standoff
Fasteners
3. Use a 3 mm hex wrench to reinstall the touchscreen mounting screw (1). See
Note: Touchscreen calibration should be performed after proper touchscreen
operation is confirmed. See
Mounting Plate Slots and Alignment
Mounting
Figure
"Touchscreen Calibration" on page
185
7-27.
Mounting
Figure
154.
7-26.