Touchscreen Display - Stratasys F170 User Manual

TOUCHSCREEN DISPLAY

Required Tools
• 3 mm hex wrench
Removing the Touchscreen Display
Caution: The connectors and cables of the touchscreen display are fragile.
Excessive force may cause damage to connector pins or wiring.
1. Power OFF the printer. See
2. Using a 3 mm hex wrench, remove the mounting screw (1) that secures the touchscreen to the
display panel bracket. See
3. Gently lift the touchscreen slightly to disengage the standoff fasteners (4) from the display panel
bracket. See Figure
4. While supporting the touchscreen, tilt it away from the bracket to disconnect the touch extender
cable and the display cable from the back of the display.
Note: The flat display cable connector is fragile. Simultaneously pull both
corners of the connector straight out, without rocking back and forth.
5. Gently move the touchscreen away to remove it from the printer. See
Figure 7-26:
"Powering Off" on page
Figure 7-26.
7-26.
Touchscreen Mounting Screw Location
169.
184
Figure 7-26.