Powering Off The Printer - Stratasys F170 User Manual
F123 series shared office 3d printers
Hide thumbs
Also See for F170:
- Operation and maintenance manual (91 pages) ,
- Site preparation manual (22 pages)
Table of Contents
Advertisement
POWERING OFF THE PRINTER
To power the printer OFF:
1.
Ensure that the printer is stopped (idle) and is not building.
2.
Press the Power button located on the front of the printer (see
3.
A dialog will be displayed asking you to confirm the power OFF; press Yes to power OFF.
Figure 5-4:
Power OFF Confirmation
4.
After a couple of minutes the printer will shutdown.
Please note that this procedure only powers down the electronics. To completely disengage power to the
printer, you must unplug the power cord located at the rear of the printer.
Note: For extended non-use periods greater than 72 hours, unload the material,
store the material in an air tight bag and power OFF the system.
Figure 5-1
107
for button location).
Advertisement
Table of Contents
