TOP COVER INTERLOCK SENSOR AND ACTUATOR
Required Tools
2 mm hex wrench
•
2.5 mm hex wrench
•
Removing Top Cover Interlock Sensor
1.
Power OFF the printer. See
2.
Open the front top cover.
3.
Disconnect the top cover sensor cable at the quick disconnect.
4.
Remove the three cable ties that secure the cable to the sensor mounting bracket.
5.
Use a 2 mm hex wrench to remove the sensor mounting screws (2). See
6.
Remove the top cover sensor from the mounting bracket.
Figure 7-44:
7.
Use a 2.5 mm hex wrench to remove the top cover actuator mounting screws (2). See
8.
Remove the top cover actuator.
Figure 7-45:
"Powering Off" on page
Top Cover Sensor Mounting Screw Locations
Top Cover Actuator Mounting Screw Locations
169.
202
Figure
7-44.
Figure
7-45.