Drive And Driven Pulleys; Battery - Can-Am MAVERICK Trail 2021 Series Operator's Manual

tmo2013-003-060_a
1. Lowest portion of cogs even with external
surface of drive belt

Drive and Driven Pulleys

Drive and Driven Pulleys Inspection
This inspection must be performed by
an authorized Can-Am dealer, repair
shop, or person of your own choosing
for maintenance, repair, or replace-
ment.
Drive Pulley
Inspect the bushings of the sliding
sheave of the drive pulley, replace
worn parts.
Driven Pulley
Inspect the bushings of the cam and of
the sliding sheave of the driven pulley,
replace worn parts.

Battery

Battery Maintenance
NOTICE
Never charge a battery
while installed in vehicle.
These vehicles are equipped with a
VRLA battery (Valve Regulated Lead
Acid). It is a maintenance-free type
battery, there is no need to add water
to adjust electrolyte level.
NOTICE
Never remove the battery
sealing cap.
Battery Removal
Remove the driver seat cushion.
Disconnect BLACK (-) cable first then
RED (+) cable.
NOTICE
for disassembly; disconnect BLACK
(-) cable first.
Remove
screw(s).
219001880-043_a
1. Battery holder
2. Battery
3. Battery holder retaining screw(s)
Remove battery holder.
Remove battery.
Battery Cleaning
Clean battery, battery casing and bat-
tery posts using a solution of baking
soda and water.
Remove corrosion from battery cable
terminals and battery posts using a
firm wire brush. Battery casing should
be cleaned by soft brush and baking
soda solution.
Battery Installation
Battery installation is the reverse of the
removal procedure.
NOTICE
the battery cables (reverse polarity)
will result in damage to the voltage
regulator.
NOTICE
cable first then BLACK (-) cable.
______________
MAINTENANCE PROCEDURES
Always respect this order
battery holder
Improper orientation of
Always connect RED (+)
retaining
123