ComAp IG-NT GC Reference Manual page 166

used for selecting language of the built-in IG-NT terminal (display). As the IS-NT
does not have built-in terminal, this input is assigned to the terminal (display) #1,
which is supposed to be directly attached to the controller or mounted close to it.
N
OTE
Using these inputs for language selection is an option only. If the inputs are not
configured, the language can be selected using the menus on the terminal.
E
NCODING TABLE
L
ANGUAGE INDEX
0
1
2
3
4
5
6
7
N
OTE
"0" in the table means the input is not active or not configured.
N
OTE
Language index 0 selects the default language of the terminal, i.e. the language,
which is adjusted in the terminal using it's menus.
N
OTE
The reaction on changes of these inputs is delayed about 1 sec to ensure the new
combination is valid (e.g. if a rotary selector switch is used).
C
AUTION
Each language change causes the reinitialization of the display. Function of the
controller is not influenced.
Binary input: Lang sel int C
Related FW 3.2
Description This is one of three binary inputs
used for selecting language of the built-in IG-NT terminal (display). As the IS-NT
does not have built-in terminal, this input is assigned to the terminal (display) #1,
which is supposed to be directly attached to the controller or mounted close to it.
N
OTE
Using these inputs for language selection is an option only. If the inputs are not
configured, the language can be selected using the menus on the terminal.
E
NCODING TABLE
L
ANGUAGE INDEX
0
Inteli NT GeCon-MARINE SPI, SW Version 3.2, ©ComAp – July 2015
IGS-NT-GeCon-MARINE-SPI-3.2.PDF
:
:
:
:
!
:
I A I B
NPUT NPUT
0 0
1 0
0 1
1 1
0 0
1 0
0 1
1 1
Lang sel int A, Lang sel int
I A I B
NPUT NPUT
0 0
I C
NPUT
0
0
0
0
1
1
1
1
B, Lang sel int C,
I C
NPUT
0
166