Table of Contents
Advertisement
Controller modes
OFF mode
Use OFF mode to block controller functions (even if is power on). OFF mode is used for controller firmware
or configuration change.
Binary outputs (e.g. GCB CLOSE/OPEN) are not energized, all closed Binary outputs are opened when
controller is switched to OFF mode.
Gen-set cannot be started and operated from IGS-NT-GeCon controller – no response for panel buttons and
Binary input commands.
Hint:
Switching to OFF mode is blocked on running engine to avoid accidental engine stop by mode change or by
firmware or configuration programming.
Inteli NT GeCon-MARINE SPI, SW Version 3.2, ©ComAp – July 2015
13
IGS-NT-GeCon-MARINE-SPI-3.2.PDF
Advertisement
Table of Contents
Need help?
Do you have a question about the IG-NT GC and is the answer not in the manual?
Questions and answers