Configuring A Session Initiator For The Iwag - Cisco Intelligent Wireless Access Gateway Configuration Manual

Overview of the Intelligent Wireless Access Gateway

Configuring a Session Initiator for the iWAG

This section describes how to configure a session initiator for the iWAG solution. A session can be created
using different triggers, such as an unknown MAC address, an unclassified MAC address, a RADIUS message
with the Cisco ASR 1000 Series Aggregation Services Router acting as RADIUS proxy or a DHCP DISCOVER
message with the Cisco ASR 1000 Series Aggregation Services Router acting as DHCP proxy.
To enable roaming, one initiator is required for DHCP sessions and another for the unclassified MAC.
Note
SUMMARY STEPS
1. enable
2. configure terminal
3. interface GigabitEthernet slot/subslot/port
4. description string
5. ip address ip-address mask [secondary [vrf vrf-name]]
6. negotiation auto
7. service-policy type control policy-map-name
8. ip subscriber {l2-connected}
9. initiator {dhcp | radius-proxy | static ip subscriber list listname | unclassified ip | unclassified
mac-address}
10. initiator {dhcp | radius-proxy | static ip subscriber list listname | unclassified ip | unclassified
mac-address}
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
interface GigabitEthernet slot/subslot/port
Example:
Router(config)# interface GigabitEthernet 1/3/3
OL-30226-03
Configuring the iWAG for 3G Mobile IP Users
Purpose
Enables the privileged EXEC mode.
Enter your password, if prompted.
Enters the global configuration mode.
Enters the interface configuration mode for Gigabit
Ethernet.
Intelligent Wireless Access Gateway Configuration Guide
15