FEB LEDs on the M120 Craft Interface
FPC LEDs on the M120 Craft Interface
Power Supply LEDs on the M120 Craft Interface
External Clocking Inputs LEDs on the M120 Craft Interface
Copyright © 2018, Juniper Networks, Inc.
Each FEB has two LEDs on the craft interface that indicate its status. The LEDs, labeled
0
through
5
, are located on the lower right of the craft interface below the
Table 5 on page 15
describes the functions of the FEB LEDs.
Table 5: FEB LEDs on the M120 Craft Interface
Label
Color
Green
ACTIVE
Green
STATUS
Red
Each FPC slot has one LED that indicates its status. The FPC LEDs, labeled
, are located along the bottom of the craft interface.
FPC5
the functions of the FPC LEDs.
Table 6: M120 FPC LEDs
Label
Color
Red
STATUS
Green
Each power supply has one LED on the craft interface that indicates its status. The LEDs,
labeled
and
, are located on the lower left of the craft interface under the
0
1
label.
Table 7 on page 15
describes the functions of the power supply LEDs.
Table 7: Power Supply LEDs on the M120 Craft Interface
Label
Color
STATUS
Red
Green
The
EXT CLOCK
ports are labeled
Chapter 3: Chassis Components and Descriptions
State
Description
On steadily
FEB is active.
Blinking
FEB is transitioning online/offline.
On steadily
FEB is functioning normally.
On steadily
FEB is not functioning normally.
State
Description
On steadily
FPC has failed.
On steadily
FPC is functioning normally.
Blinking
FPC is transitioning online/offline.
State
Description
On steadily
Power supply has failed.
On steadily
Power supply is functioning normally.
A
and
B
.
FEBS
label.
through
FPC0
Table 6 on page 15
describes
POWER
15