Operation Manual – Link Aggregation
H3C S3610&S5510 Series Ethernet Switches
Chapter 2 Link Aggregation Configuration
When configuring link aggregation, go to these sections for information you are
interested in:
Configuring Link Aggregation
Displaying and Maintaining Link Aggregation
Link Aggregation Configuration Example
2.1 Configuring Link Aggregation
This section covers these topics:
Configuring a Manual Link Aggregation Group
Configuring a Static LACP Link Aggregation Group
Configuring an Aggregation Group Name
Configuring a Service Loop Group
Entering Aggregation Port Group View
2.1.1 Configuring a Manual Link Aggregation Group
Follow these steps to create a manual aggregation group and add an Ethernet port to it:
Enter system view
Create a manual
aggregation group
Enter Ethernet port view
Assign the Ethernet port
to the aggregation group
Note that:
You can create a manual aggregation group by changing the type of an existing
static aggregation group. When you create a manual aggregation group in this
way and the static aggregation group contains ports, LACP is disabled on the ports
after the manual aggregation group is created.
An aggregation group cannot contain the following ports: RRPP-enabled ports,
reflector ports or destination ports of port mirroring groups, ports with static MAC
To do...
system-view
link-aggregation group agg-id
mode manual
interface interface-type
interface-number
port link-aggregation group
agg-id
Chapter 2 Link Aggregation Configuration
Use the command...
2-1
Remarks
––
Required
––
Required