H3C S3610-28P Operation Manual page 318

Operation Manual – IPv6
H3C S3610&S5510 Series Ethernet Switches
3.5.3 Configuration Example
I. Network requirements
Isolated IPv6 networks are interconnected through a 6to4 tunnel over the IPv4 network.
II. Network diagram
2002:0201:0101:1::1/64
2002:0201:0101:1::2/64
Figure 3-5 Network diagram for a 6to4 tunnel
III. Configuration procedure
Configuration on Switch A
# Enable IPv6.
<SwitchA> system-view
[SwitchA] ipv6
# Configure a link aggregation group. Disable STP on the port before adding it into the
link aggregation group.
[SwitchA] link-aggregation group 1 mode manual
[SwitchA] link-aggregation group 1 service-type tunnel
[SwitchA] interface Ethernet 1/0/1
[SwitchA-Ethernet1/0/1] stp disable
[SwitchA-Ethernet1/0/1] port link-aggregation group 1
[SwitchA-Ethernet1/0/1] quit
# Configure an IPv4 address for VLAN-interface 100.
[SwitchA] vlan 100
[SwitchA-vlan100] port ethernet 1/0/2
[SwitchA-vlan100] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ip address 2.1.1.1 24
[SwitchA-Vlan-interface100] quit
6to4 switch
Vlan-int100
2.1.1.1/24
Vlan-int101
Switch A
Host A
Chapter 3 Tunneling Configuration
IPv4 netwok
6to4 switch
Vlan-int100
5.1.1.1/24
Switch B
2002:0501:0101:1::2/64
3-18
Vlan-int101
2002:0501:0101:1::1/64
Host B