Configuring Dynamic Ipv6 Domain Name Resolution - H3C S3610-28P Operation Manual

Operation Manual – IPv6
H3C S3610&S5510 Series Ethernet Switches
Follow these steps to configure static IPv6 domain name resolution:
Enter system view
Configure a host name
and the corresponding
IPv6 address

1.9.2 Configuring Dynamic IPv6 Domain Name Resolution

If you want to use the dynamic domain name function, you can use the following
command to enable the dynamic domain name resolution function. In addition, you
should configure a DNS server so that a query request message can be sent to the
correct server for resolution. The system can support at most six DNS servers.
You can configure a DNS suffix so that you only need to enter some fields of a domain
name and the system can automatically add the preset suffix for address resolution.
The system can support at most 10 DNS suffixes.
Follow these steps to configure dynamic IPv6 domain name resolution:
To do...
Enter system view
Enable the dynamic
domain name
resolution function
Configure an IPv6
DNS server
Configure the DNS
suffix.
Note:
The dns resolve and dns domain commands are the same as those of IPv4 DNS. For
details about the commands, refer to DNS Commands.
To do...
system-view
ipv6 host hostname
ipv6-address
Use the command...
system-view
dns resolve
dns server ipv6
ipv6-address
[ interface-type
interface-number ]
dns domain
domain-name
Chapter 1 IPv6 Basics Configuration
Use the command...
—
Required
Disabled by default.
Required
If the IPv6 address of the DNS
server is a link-local address, you
need to specify a value for
interface-type and
interface-number.
Required
By default, no DN suffix is
configured, that is, the domain
name is resolved according to
the input information.
1-23
Remarks
—
Required
Remarks